If you have successfully set up your compatible hub but cannot get a connected cree led bulb to pair with the hub in the applicable app you can factory reset your bulbs. Step 1 install your bulb in a light fixture and turn it on.
Cree Connected Lightbulb
Cree connected bulb reset. Repeat steps 2 and 3 until the bulb momentarily dims about 4 or 5 times 5. Registered hubitat and created a new dasboard. Starting with the. Turn the bulb off for 2 seconds 4. Unpaired all 4 bedroom cree connected bulbs with the smartthings hub. Ive reset several bulbs to factory default changed lamps moved the lamp close to the hub all to no avail.
Make sure the bulb is installed and turned on in the smartthings app tap my home turn the bulb off for 2 seconds and then turn it on for 1 second. The smartthings hub isnt plugged in batteries out too. To physically reset the cree connected led bulb. Turn the bulb on for 1 second 3. Try a manual reset belkin wemo leds. Repeat steps 2 and 3 until the bulb momentarily dims about 4 or 5 times 5.
Start with the wemo led on then flip the switch off and wait 1 second before flipping it back on. Connected by tcp leds. 1begin with the bulb turned off. I could pair my 4 other bulbs without any problem. Begin with the bulb turned off 2. Notice on step 2 1 second not 2.
Cycle the bulb on for 5 seconds then off for 5 seconds a total of five times. Factory reset each cree bulb. Turn the bulb on for 1 second. Turned on cree bulb. Turn on the bulb wait about a second and then turn it off wait 2 seconds turn on the bulb wait about a second and then turn it off wait 2 seconds turn on the bulb wait about a second and then turn it off wait 2 seconds turn on the bulb wait about a second and then turn it off wait 2 seconds. I tried doing a full reset on my hubitat and starting over.
Good morning i just purchased 6 cree connected 60w bulbs and am unable to pair them with my smartthings hub version 2. This makes all the difference. Turn the bulb off for 2 seconds. To reset the cree connected led bulb turn the bulb off for two 2 seconds then on for one 1 second repeat 4 times. Notice on step 2 1 second not 2 as cree and others have documented. Went to zigbee pairing mode.
It will only dim for a second signaling that it has been factory reset. It will only dim for a second signaling that it has been factory reset. For best results we recommend installing the bulb where you can turn the power off at a wall switch.
Gallery of Cree Connected Bulb Reset
